32
6.4.2. MANUAL CHANNEL SCAN
In manual search the number of the multiplex is entered manually and only that multiplex is searched
for the channels. In manual and auto search, any existing channel in the database is not re-stored to
avoid redundant duplicates of that channel. To start the scan enter the channel number manually and
press OK.
6.4.3. FIRST TIME INSTALLATION
Use this option to load default settings, which had been set at the factory. To install factory settings,
highlight ‘First Time Installation’ menu and press OK key, then you will be asked to confirm deleting all
channels and settings. Selecting YES and pressing OK will delete the channel table. Selecting "NO"
and pressing OK will cancel the operation.
7. MESSAGES
When the box receives no signal (e.g. the aerial cable is disconnected), “NO SIGNAL” message is
seen on the screen.
When there are no channels stored in the box; the Channel List menu is not accessible. Channel
navigation is not allowed. Therefore, trying to enter these menus or navigate the channels will display
an error message on the screen.
A conflict is caused, if more than two programmes are set for recording in the same time interval. To
solve this conflict, you have to select an alternative for one of those programmes. If there are no
alternatives, the warning message on the right will appear.
If there is still a conflict and you leave this menu by pressing the OK button, you will see this warning
message: “There are still conflicts!”.
Summary of Contents for HDR163 ARGOS
Page 42: ...www hitachidigitalmedia com ...
