-4-
Guide Plate
OFF side
ON side
Internal wire from Cord
[51]
Machine Screw (W/Washer) M3.5 x 6
[49]
Switch (1P Solder Type)
[50]
Internal wire from Stator
[27]
Internal wire from Noise Suppressor
[45]
Machine Screw (W/Washer) M3.5 X 6
[49]
: Tail Cover (A)
[34]
(7) Correctly connect the internal wires of the Stator
[27]
as shown in Fig.
5
and Fig.
6
.
(8) Correctly connect each internal wire as shown in Fig.
4
, and be careful not to route the
wires between any parts.
Fig. 5
Fig. 6
(9) When replacing the Gear Cover Ass’y
[2]
, lubricate the needle bearing part with mixed oil.
Mixed oil: A mixture of Hitachi Power Tool Grease No. 2 (Unilube No. 00, Code No. 939302
recommended) and turbine oil
• Mixture ratio ------------------------- 1:1 (weight ratio)
• Quantity ------------------------------ 0.5 cc
Colorless
Bottom of the housing
Internal wire coming from the
Noise Suppressor
[45]
Brush Holder
[39]
Insert the terminal securely then push
and fold the terminal toward the outside
of the housing as much as possible.
Colorless
