--- 14 ---
(iii) Install Washer (B) [23] in the Rear Case [14] with the projections of Washer (B) [23] engaged with the
recesses in the Rear Case [14], and turn Washer (B) [23] clockwise until it can turn no further. (See
Fig. 10.)
Fig. 10
Recess
Projection
Projection
[23]
(c) Install the Click Spring [8] and the Cap [4] on the assembly reassembled in step (b). (See Fig. 11.)
(i) Insert the projection of the Click Spring [8] into the hole of the Front Case [9].
(ii) Mount the Cap [4].
Mount the Nut [5] into the Cap [4] engaging the wider projection of the Nut [5] with the wider recess of
the Cap [4]. (The wider recess of the Cap [4] is positioned at "1" when viewed from the outside.)
(iii) Apply grease (Hitachi Motor Grease No. 29, Code No. 930035) to the sliding surfaces of the Cap [4]
and the Click Spring [8].
Fig. 11
Cap [4]
Click Spring [8]
Hole
Pro-
jection
Wider recess
"1"
Recesses
Cap [4]
Nut [5]
Wider projection
Nut
Projections
(d) Install the Shift Arm [16] into the assembly reassembled in step (c).
With the ridge at the Shift Arm [16] facing the Motor [25] side, first install them on the unmarked side of the
assembly reassembled in step (c). Then insert the projections on the Shift Arm [16] into the holes in the
Rear Case [14] and make sure that the projections are fitted into the grooves in the Slide Ring Gear [17]
mounted within the Rear Case [14]. (See Fig. 12.)
