E-20
Operation Panel
Display
Display Contents
Example
Display 1
Select operation mode and airflow rate by
tapping the panel.
For power saving, the display and operation
panel other than the notifi cation display and
the air sensor will turn off approximately one
minute after the unit stops operating.
Display 2
When all indicators are on, tapping the op-
eration panel and selecting operation mode,
airfl ow rate or other similar buttons will make
the display light of the selected buttons
brighter.
* The display may not be clear to look at
when the unit is placed near windows with
direct sunlight, and other similarly bright
places.
Off
Display is the same as Display 1.
The display, operation panel, notifi cation dis-
play, and clean monitor go off approximately
one minute after the unit stops operating.
Switching Touch Operation Panel Display
Use this to adjust the unit to your preferred setting.
Display Contents of the Operation Panel
In this instruction manual, the following examples are described in Display 1.
The touch operation panel display will switch at each press.
Display 1
Display 2
Off
(When switching from Off to Display 1, the buzzer will ring twice
(beep, beep) and the display will blink once. )
Long-press for about 3 seconds and select touch operation panel
display
Display
·
Dimmer
Type 1/2/Off
(When selecting Air Purify / Max)
(When selecting Air Purify / Max)
(When indicators are dimmed)
If the lights in the touch operation panel display are turned off, tap the
and operate after the panel is dis-
played.
(Tapping the
again turns off the indicator of the touch operation panel display.)
Operation
(Continued)
EP-M70E_EN.indd 20
EP-M70E_EN.indd 20
2017/2/23 17:27:42
2017/2/23 17:27:42
