E-22
When the “Clean Humidifying Filter” Indicator Comes On
Cleaning
Remove the water tank and then
pull out the water tray.
Remove the humidifying filter from
the water tray.
Clean the humidifying filter, water tray and tray cover.
Install the water tray, and then
mount the water tank.
Plug the power cord into the AC
outlet and press the reset button
located behind the panel.
Remove the panel.
Mount the panel on the purifier.
Set the humidifying filter.
Slowly insert the humidifying filter into the tray cover.
Insert the filter fully until it comes into positive contact
with the bottom of the tray. Inadequate fitting may cause
water to leak during operation.
(Use the tip of a ball point pen or similar object.)
Check that the “Clean” indicator is now OFF.
P.
E-23, E-24
P.E-10
When the unit is shaken or rocked, water may gather in a part other than that where the humidifying
filter of the water tray is installed.
After you pull out the water tray, be sure to remove the tray cover and wipe off any water that exists or clean it.
Before cleaning, be sure to stop operation and unplug the power cord from the AC outlet.
When the “Clean Humidifying Filter” indicator lights up, clean the humidifying filter, water tray and tray cover.
The “Clean Humidifying Filter” indicator will come on approximately one month (approximately 720 hours)
after the start of use or after the reset button was pressed after the previous cleaning operation finished.
Depending on the tap water used, water scale may adhere earlier. If there is heavy filter contamination, clean
the filter more than once a month before the “Clean Humidifying Filter” indicator lights up.
After cleaning, press the reset button. The “Clean Humidifying Filter” indicator will go off.
Do not splash water on the unit. Doing so may cause a unit failure.
Do not use volatile solvents, such as gasoline, thinner, benzene, wax, kerosene, alcohol, etc. or polishing
powder, or detergent (used for kitchen or laundry).
Such chemicals could cause deformation, discoloration, damage or removal of prints.
Do not tip over or tilt the unit.
When using a chemically treated cloth, follow relevant instructions.
Never use a dryer or heater to dry the unit case. Heating could cause deformation, discoloration,
damage or removal of prints.
Lay a soft cloth or similar material beneath the unit to protect the floor against scratches.
P.
E-9
When you pull out the water tray from the unit, water may spill out or the floor may be scratched by
the tray bottom. Lay a soft cloth or similar material beneath the unit to protect the floor.
P.E-9
Water
tray
Slowly pull out the
water tray while lifting
it upward at an angle.
Humidifying filter
Water tray
CAUTION
WARNING
CAUTION
7B6(3$LQGG
“Clean” indicator (Red)
Reset button
手前
手前
手前
Marking
Humidifying filter
