E-18
Memory Function / Sensors / Auto Detection
Memory Function
When you stop operation and then restart, the purifier will resume the operation that was running before shutdown.
If you operate the Purifier for approximately 5 seconds or longer, the operation status will be stored in memory.
(If you stop operation before 5 seconds have elapsed, the operation status will not be stored in memory.)
Even if you unplug the power cord, the operation status will be stored in memory. However, the airflow rate is
automatically set to “Auto”.
Air Sensor
Level of air contamination detected by the odor sensor and dust sensor is shown by the way the indicator is activated.
Indicator action : Light up in green
Blink in green
Contamination level: Clean
Contaminated
Note
You can adjust the air sensor and dust sensor sensitivity setting as desired.
P.E-20
In case the purifier is installed in a location where air contamination is difficult to
detect or in case the sensor itself is not clean, the indicator action may not change.
P.E-29
Odor Sensor
The sensor detects odors in the air such as cigarette smoke or animal odors.
Even if you think the air is clean, the unit may continue the operation if the odor
sensor detects any gas component that has not been removed by the filter.
Any of the following may also be detected by the odor sensor.
Combustion gases from heating appliances, alcohol, odor of perfumes or cos-
metics used in beauty parlors or aesthetic salons, sprays, vapors, abrupt tem-
perature changes, etc.
Using the Control on Unit
Press
button.
Operation starts.
Every time you press the
button, the operation
mode switches in the following sequence so that you
can choose a desired mode or stop.
The airflow rate is set to “Auto” by switching the
operation mode.
Air
Purify
Pollen
Strong
Deodorization
Humidify
Skin
Moisturize
Off
7B6(3$LQGG
Ai r
Sensor
r
Clean
Humidifying
Filter
Skin
Moisturize
Ai r
Sensor
r
Timer(4hrs)
Max(Blinking)
Odor sensor
