--- 23 ---
(i) Note the direction of the groove when installing the Slide Ring Gear
[17] <17>
so that the groove faces
toward the Motor
[25] <25>
.
(ii) Install the Front Case
[9] <9>
and the Rear Case
[14] <14>
together with the mark on the Front Case
[9] <9>
aligned with the mark on the Rear Case
[14] <14>
. (See Fig. 12.)
(iii) Install Washer (B)
[23] <23>
in the Rear Case
[14] <14>
with the projections of Washer (B)
[23] <23>
engaged with the recesses in the Rear Case
[14] <14>
, and turn Washer (B)
[23] <23>
clockwise until
it can turn no further. (See Fig. 11.)
Fig. 11
Recess
Projection
Projection
[23] <23>
Fig. 12
(c) Install the Shift Arm
[16] <16>
into the assembly reassembled in step (b).
With the ridge at the Shift Arm
[16] <16>
facing the Motor
[25] <25>
side, first install them on the unmarked
side of the assembly reassembled in step (b). Then insert the projections on the Shift Arm
[16] <16>
into
the holes in the Rear Case
[14] <14>
and make sure that the projections are fitted into the grooves in the
Slide Ring Gear
[17] <17>
mounted within the Rear Case
[14] <14>
. (See Fig. 12.)
(d) Install the Drill Chuck
[2] <2>
.
Install the Drill Chuck
[2] <2>
using the special repair tool (J-342, Code No. 324-582) and secure it with the
Special Screw (Left Hand) M6 x 23
[1] <1>
.
(e) Install the Shift Knob
[35] <36>
into the assembly reassembled in step (d).
When installing the Shift Knob
[35] <36>
into the Shift Arm
[16] <16>
, note that the "LOW" mark on the
Shift Knob
[35] <36>
faces the Motor
[25] <25>
with the Shift Arm
[16] <16>
engaged with the recess in
the Shift Knob
[35] <36>
.
[16] <16>
[16] <16>
Ridge
Mark
Groove
Hole
