English
7
Voltage (by areas)*
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
Input*
1140W
Capacity
Drill bit: 50 mm
Core bit: 125 mm
No load speed
300 min
-1
Full-load impact rate
2450 min
-1
Weight (without cord, side handle)
9.8 kg
* Be sure to check the nameplate on product as it is subject to change by areas.
䡬
Large-dia. hole boring (Ro Striking):
(1) Center Pin
(Guide
(2) Core
(3) Core bit
plate)
bit
shank
(1) Center pin
Applied to core bits from 50 mm to 125 mm.
(2) Core bit
External dia.: 50, 65, 80, 90, 100, 125 mm
(3) Core bit shank
䡬
Crushing:
(1) Cold chisel
Total length: 300, 380, 450 mm
䡬
Groove digging and edging:
(1) Cold chisel
Total length: 300, 380, 450 mm
䡬
Asphalt cutting:
(1) Cutter
Width: 50, 75 mm
Total length: 400 mm
SPECIFICATIONS
STANDARD ACCESSORIES
(1) Case ........................................................................... 1
I type: Side handle ...................... 1
(2) Side handle
II type: Bar type handle ............... 1
D type handle .................. 1
Either type I or type II Side handle is attached.
(3) Stopper (I type Side handle only) ....................... 1
(4) Dust cover ................................................................. 1
(5) Hammer grease A ................................................... 1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
䡬
Through-hole drilling:
(1) Drill bit (hexagon shank)
Total length: 420, 570 mm
External dia.: 16, 18, 20, 22, 25, 28, 30, 32, 35, 38,
40, 44, 50 mm
䡬
Anchor hole drilling (Ro Striking):
(3) Cotter
(1) K-Taper shank adapter
(2) A-Taper
sleeve
ROTARY HAMMER SAFETY WARNINGS
1.
Wear ear protectors.
Exposure to noise can cause hearing loss.
2.
Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3.
Do not touch the bit during or immediately after
operation. The bit becomes very hot during
operation and could cause serious burns.
4.
Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.
5.
Always hold the body handle and side handle of
the power tool firmly. Otherwise the counterforce
produced may result in inaccurate and even
dangerous operation.
6.
Wear a dust mask
Do not inhale the harmful dusts generated in
drilling or chiseling operation. The dust can
endanger the health of yourself and bystanders.
01Eng_DH50SA1_WE
12/10/08, 17:03
7
Summary of Contents for DH 50SA1
Page 2: ...1 1 2 4 6 8 3 5 7 00Table_DH50SA1_WE 12 10 08 17 02 1 ...
Page 3: ...2 9 11 13 15 71 10 12 14 00Table_DH50SA1_WE 12 10 08 17 02 2 ...
Page 47: ...46 09Back_DH50SA1_WE 12 10 08 17 05 46 ...
Page 48: ...47 09Back_DH50SA1_WE 12 10 08 17 05 47 ...
