--- 31 ---
(3) Reassembly of the change lever
Press the Pushing Button
[18]
deeply into the hole of the Change Lever
[21]
. Adjust the Change Lever
[21]
to
the position shown in Fig. 23 of the Gear Cover Ass'y
[10]
and press it hard. Then move the Change Lever
[21]
to the "hammering only" position ( mark).
Pushing Button
[18]
Fig. 23
Change Lever
[21]
(4) Press-fitting the first gear
Press-fit the First Gear
[54]
aligning with the shaft end surface of the Second Shaft
[52].
After press-fitting
the First Gear
[54]
, check that the inside ring of the Reciprocating Bearing
[53]
turns smoothly.
(5) Reassembly of the oil seal
Prior to reassembly, apply grease to the inner circumference of the Oil Seal
[12]
. However, do not apply
grease to its outer circumference. Also, when press-fitting the Oil Seal
[12]
, ensure that it is straight and level.
(6) Reassembly of the internal pressure adjustment mechanism
Push Felt Packing (A)
[44]
, Valve
[45]
and Felt Packing (B)
[46]
in the Inner Cover Ass'y
[41]
as far as they
will go in this order.
Fig. 24
Inner Cover Ass'y
[41]
Valve
[45]
Felt Packing (B)
[46]
Felt Packing (A)
[44]
Summary of Contents for DH 24PC3
Page 38: ... 35 Fig 30 2 Product without noise suppressor ...
Page 47: ......
