Hitachi dh 24dvc, Handling Instructions Manual

Page: 12 / 88

11
English
APPLICATIONS
Rotation and hammering function
䡬
Drilling anchor holes
䡬
Drilling holes in concrete
䡬
Drilling holes in tile
Rotation only function
䡬
Drilling in steel or wood
(with optional accessories)
䡬
Tightening machine screws, wood screws
(with optional accessories)
Hammering only function
䡬
Light-duty chiselling of concrete, groove digging
and edging.
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery latches
to remove the battery. (see
Figs. 1 and 2 )
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery aligning both guide rail of battery
and body. Make sure the battery is fixed firmly.
NOTE
Push the battery hard against the rubber cushion
and hook the latch completely. (
Fig. 2 )
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger’s power cord to a receptacle.
When the power cord is connected, the charger’s
pilot lamp will blink in red. (At 1-second intervals)
2. Insert the battery into the charger.
Insert the battery into the charger as shown in Fig.
3 . Make sure the battery is fully seated in the
charger.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals) (See
Table 1 )
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in
Table 1 , according to the condition of the charger
or the rechargeable battery.
䢇
Drilling holes in concrete or tile
Drill bit (slender shaft)
Outer dia. Overall length Effective length
3.4 mm
90 mm 45 mm
3.5 mm
Taper shank adapter
Taper mode
Morse taper No.1
Morse taper No.2
A-Taper
B-taper
䢇
Drilling anchor holes
Anchor setting adapter
Anchor size
W 1/4”
W 5/16”
W 3/8”
䢇
Anchor setting
Optional accessories are subject to change without notice.
SDS-plus Drill bit
Outer dia. Overall length Effective length
4.0 mm 110 mm 50 mm
5.0 mm
110 mm 50 mm
160 mm 100 mm
5.5 mm 110 mm 50 mm
6.5 mm 160 mm 100 mm
7.0 mm 160 mm 100 mm
8.0 mm 160 mm 100 mm
8.5 mm 160 mm 100 mm
9.0 mm 160 mm 100 mm
12.0 mm
166 mm 100 mm
260 mm 200 mm
12.7 mm 166 mm 100 mm
14.0 mm 166 mm 100 mm
15.0 mm 166 mm 100 mm
16.0 mm
166 mm 100 mm
260 mm 200 mm
17.0 mm 166 mm 100 mm
19.0 mm 260 mm 200 mm
20.0 mm 250 mm 200 mm
01Eng_DH24DVC(S)_WE 4/17/12, 9:23 11