--- 23 ---
Pushing Button [12]
Fig. 12
Fig. 13
Change Lever [14]
Second Shaft [44]
Reciprocating
Bearing [48]
First Gear [49]
Piston [37]
2-mm diameter holes (2 pcs.)
(3) Press-fitting the first gear
Press-fit the First Gear [49] aligning with the shaft end surface of the Second Shaft [44]. After press-fitting the
First Gear [49], check that the inside ring of the Reciprocating Bearing [48] turns smoothly.
(4) Reassembly of the oil seal
Prior to reassembly, apply grease to the inner circumference of the Oil Seal [16]. However, do not apply
grease to its outer circumference. Also, when press-fitting the Oil Seal [16], ensure that it is straight and level.
(5) Mounting the piston
Mount the Piston [37] facing its two 2-mm diameter holes to the Second Shaft [44] as shown in Fig. 13.
9-3. Tightening Torque
Tapping Screw D3 x 10 [68] ........................................................... 0.7 0.2 N
•
m (7.5 1.5 kgf
•
cm, 6.5 1.3 in-lbs.)
Tapping Screws D4 [59] [79] [80] .................................................. 2.0 0.5 N
•
m (20 5 kgf
•
cm, 17.4 4.3 in-lbs.)
Tapping Screw (W/Flange) D5 x 35 [9] .......................................... 2.9 0.5 N
•
m (30 5 kgf
•
cm, 26.0 4.3 in-lbs.)
Striker [35]
Inner Cover [39]
Summary of Contents for DH 22PB
Page 38: ......