Hitachi D 10VJ, Technical Data And Service Manual

Page: 19 / 41

--- 16 ---
8-2. Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to the following items.
8-2-1. Internal wire arrangement
(1) Arrange the internal wires according to "8-4. Internal Wire Arrangement and Wiring Work".
(2) Be careful not to catch the internal wires when mounting the handle cover.
8-2-2. Lubrication
(1) Apply ATTLUB MS No. 2 Grease to the following parts.
Teeth of the Second Pinion and Gear Set [11] <11> (11) and the Gear Set [21] <21> (21) .
On the Spindle [4] <4> (4) .
Ground portion for fitting the Ball Bearing 6202DDCMPS2L [6] <6> (6) , splined portion and hole of rear side.
On the Shift Lever Ass'y [15] <15> (15) .
Outer circumference portions of the Shift Pin [14] <14> (14) and the O-ring (S-22) [13] <13> (13) .
On the Inner Cover [12] <12> (12) .
Metal portion.
Inside of Gear Cover (A) [9] <9> (9) : 5 g
8-2-3. Tightening torque
(1) Flat Hd. Scerw (A) (Left Hand) M6 x 25 [1] <1> (1)
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
4.0 to 5.0 N
•
m (39.0 to 47.8 in-lbs.)
(2) Tapping Screw (W/Flange) D4 x 20 (Black) [32] <31> (31)
• • • • • • • • • • • • • • • • • • • • •
1.5 to 2.5 N
•
m (13.3 to 22.1 in-lbs.)
(3) Tapping Screw (W/Flange) D5 [8] <8> (8)
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
2.4 to 3.4 N
•
m (21.3 to 30.1 in-lbs.)
(4) Drill Chuck [3] <3> (3)
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
29.4 to 39.2 N
•
m (260 to 347 in-lbs.)