Hitachi D 10VF, Technical Data And Service Manual

Page: 8 / 104

--- 5 ---
Used extensively for drilling between joints, studding, in tight corners or in close quarters on machinery and
equipment. Provides two additional drilling speeds.
Chuck transferred from drill to LOW spindle of angle unit, the drilling speed is decreased to about 70% and the
drilling torque increased to about 150%.
Chuck transferred to HIGH spindle of angle unit, the drilling speed is increased to about 150% and the drilling
torque decreased to about 70%.
The table below shows the drilling capacities when attaching the angle attachment ass'y.
For attaching procedure of the angle attachment ass'y, refer to "7-5. Attaching Angle Attachment Ass'y" in this
manual.
Model
Speed of angle unit
Steel
Capacities
Wood
Twist bit
Auger bit
Flat spade bit
Hole saw
Hole saw
D 13VF D 13VG
LOW (400/min.)
HIGH (900/min.)
LOW (650/min.) HIGH (1350/min.)
13 mm (1/2")
64 mm (2-1/2")
40 mm (1-9/16")
38 mm(1-1/2" )
114 mm(4-1/2" )
13 mm (1/2")
32 mm(1-1/4" )
32 mm (1-1/4")
29 mm (1-1/8")
64 mm (2-1/2")
13 mm (1/2")
70 mm (2-3/4")
40 mm (1-9/16")
38 mm(1-1/2" )
114 mm (4-1/2")
13 mm (1/2")
51 mm (2")
40 mm (1-9/16")
32 mm (1-1/4")
102 mm (4")
<For D 13VF and D 13VG>
Angle attachment ass'y (Code No. 319528)