OPERATION PROCEDURE
13
ENG
L
IS
H
7.4.
TEMPERATURE SETTING PROCEDURE
RUN/STOP
UNIT SELECTION
TEMP.
RESET
CHECK
MODE CHANGE
TIMER
DISP.MODE
A/C／H.STRG
OPTION
GROUP
ABNML
MULTI
HEAT
SET TEMP.
COOL
UNIT No.
℃
6
5
1
4
3
2
8
7
NO FUNC.
EMG.STOP
INDVDL
TIMER
CHECK
OUTLET
INLET
A/C
H.STRG
MPa
TEMP. PR.
H.RCV.
DEMAND
LOCAL
CAUTION:
-
Do not touch “CHECK” switch.
-
“CHECK” switch is for servicing only.
-
If the mode is changed to checking mode by incorrect operation, the mode is changed to
previous mode by pressing “RESET” switch.
1. Select the unit by pressing “UNIT SELECTION” switch.
(Refer to item 1 of page. 11)
NOTE:
This procedure is not performed during multiple-unit
control.
1
4
3
2
SET TEMP.
COOL
UNIT No.
℃
INDVDL
A/C
2. Press “TEMP” switch and set required temperature.
Press “ “ switch at once, setting temperature is
increased by 1
°
C. Press “ “ switch at once, setting
temperature is decreased by 1
°
C.
Temperature setting range is different according to the
unit.
1
4
3
2
SET TEMP.
COOL
UNIT No.
℃
INDVDL
A/C
NOTE:
Setting temperature is changed continuously if pressing the switch is maintained.
In case of the multiple-unit control is selected and “UNIT SELECTION” switch is pressed, “NO
FUNC.” is indicated. Unit No. is always indicated “AA” when all the units are operated
simultaneously, in normal mode.
The above figure shows the
case of selecting unit No.4.
The above figure shows the
case of setting temperature at
12°C.
CHECK
1
2
