• The remote control works with both the
projector's front and rear remote sensors.
• The range of the remote sensor on the front is 3
meters with a 60-degree range (30 degrees to the
left and right of the remote sensor), and back is 3
meters with a 40-degree range.
• Since the remote control uses infrared light to send
signals to the projector (Class 1 LED), be sure to use
the remote control in an area free from obstacles
that could block the remote control's output signal to
the projector.
• The wired remote control:
You can use the remote control as a wired remote control, by connecting the REMOTE CONTROL ports of the
main unit and remote control via an audio cable (3.5 dia. stereo mini cable with plugs).
approximately
3 meters
3
0
d
e
g
re
e
s
30 degrees
approximately
3 meters
2
0 d
e
g
re
e
s
20 degre
es
Precautions to observe when using the remote control
• Do not disassemble the remote control.
• Do not drop or otherwise expose the remote control to physical impact.
• Do not get the remote control wet or place it on wet objects. Doing so may result in malfunction.
• Do not place the remote control near the projector’s lens, fan, or vents.
• Remove the batteries from the remote control and store them in a safe place if you
won't be using the remote control for an extended period.
• Replace the batteries whenever the remote control starts to malfunction.
• When strong light, such as direct sunlight or light from an extremely close range (such as from an
inverter fluorescent lamp), hits the projector's remote sensor, the remote control may cease to function.
Adjust the direction of the projector to keep light from directly hitting the projector's remote sensor.
ATTENTION
14
Operating the remote control
USING THE REMOTE CONTROL (continued)
WARNING • The laser pointer of the remote control transmitter is used in
place of a finger or rod. Never look directly into the laser beam outlet or point
the laser beam at other people. The laser beam can cause vision problems.
CAUTION • Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation exposure.
This remote control has the switch to disable the laser function. Refer to "The Remote Control".
01CP-X870Vol1/E-責 03.1.9 4:19 PM ページ 14
