Hitachi CP-SX5500W, Service Manual

Page: 19 / 64

19
CP-SX5500W
Before Replacing the LCD / Lens Prism
You should not replace separately the parts of the liquid crystal LCD / Lens Prism because it works properly only
when used together. Therefore, regarding these parts, you can either replace part , LCD / Lens Prism Ass'y, or
send the whole unit LCD / Lens Prism Ass'y back to Hitachi, where we will replace the malfunctioning part,
recondition the device and send it back to you. In that case please contact our distributor.
Do not disassemble the unit
because replacement of separate
parts is not possible.
For repairs of the product, please
contact our distributor.
DISTRIBUTOR HITACHI
Replacement of G Panel Reconditioning
Return
CAUTION
Use only the specifi ed batteries with this remote control transmitter. Also, do not mix new and old
batteries. This could cause in battery cracking or leakage, which could result in fi re or personal injury.
When loading the batteries, make sure the plus and minus terminals are correctly oriented as
indicated in the remote control transmitter. Incorrect orientation could cause battery cracking or
leakage, which could result in personal injury or pollution of the surrounding environment.
When you dispose the battery, you should obey the law in the relative area or country.
Keep the battery away from children and pets.
When not to be used for an extended period, remove the batteries from the remote control transmitter.
Loading the Batteries
Install the AA batteries into the remote control transmitter.
1. Remove the battery cover.
Push the knob while lifting up the battery cover.
2. Load the batteries.
Make sure the plus and minus poles are correctly oriented.
3. Close the battery cover.
NOTE:
Replace the batteries when remote control transmitter operation becomes diffi cult.
Place horizontally after removing
LCD/Lens Prism Ass’y.
1
2
G Panel
Don’t touch here.
The LCD/Lens Prism assembly should be installed, facing in
the direction as shown on the right figure. Improper installation
may distort the convergence.
Please take care not to jolt the LCD/Lens Prism assembly.
This can result in damage to the LCD panel.
Replacing the LCD/Lens Prism assembly, Be careful for dust
is not attached.
Moreover, Please clean up a duct, air filter, etc.
Table