5-4
Installing a driver
PCI-Express Dual Port 10 Gigabit LAN Card Instruction Manual
8.
Click
Hardware
of
Control Panel
and then click
Device Manager
of
Devices and Printers
. In the Device Manager window, you can see
Broadcom BCM57810 NetXtremeII 10GigE(NDIS VBD Client)
under
Network adapter
.
9.
Check the IP address. The initial value is obtained automatically. If the
fixed valuse is to be used, it is necessary to change the IP address setting.
After setting, check to connect the LAN cable to its destination such as a
hub and then restart the system unit.
When completed the driver set-up, the message
This device cannot
start. (Code10)
may appear. In this case, restart the system unit and
it will work properly. After rebooting, check
Device Manager
to work
the driver properly.
Restrictions to change parameters of the network adapter
After changing the network adapter setting, transmission may not be
made normally with the changed adapter. Check the changed network
adapter in the Device Manager window. If "
!
" is displayed, right-click the
adapter and disable it. Then enable the adapter again. The adapter
becomes available.
In an item of
Speed & Duplex
, please do not change setting of
1Gb
Full
.
Click
Control Panel
,
Network and Internet
,
Network and Sharing
Center
, and
Change adapter settings
in this order. The IP address
can be changed by clicking the
Properties
button of
Local Area
Connection
and selecting a property of
Internet Protocol Version *
(TCP/Ipv*)
. The location of the LAN Card can be checked by clicking
the
Configure
button.
When more than one LAN Card are mounted, set different network IDs
(the part masked by a subnet mask) for individual Cards. If the same
network ID is set for more than one LAN Card, the system unit may lack
of stability.
