4-2
Installing the Card
PCI-Express Dual Port 10 Gigabit LAN Card Instruction Manual
System configuration and installation procedure
Install the LAN Card into the PCI slot of the system unit. For the procedures to
install the system unit, see the manual supplied with the system unit.
When this Card is replaced, its unique information (example: MAC
address) is changed.
How to connect the Card
This section describes how to connect the Card.
Signal cables
■
Lay the cables carefully to prevent your foot from being snagged by
them. If you stumble over the cable, it may cause personal injury or
malfunction of the connection devices. Also it may cause the data to be
lost.
■
Do not put something heavy on the cable. Do not lay the cable near a
heater. The cable coating may be damaged which may cause a failure of
the connected equipment. See page 4-2 Connecting a LAN cable.
Laser beam
On this product, a Class 1 laser defined by IEC60825-1 product is
installed. Do not look directly at the laser beam.
Do not look at the laser beam using an optical device.
Under the laser module cover, a laser beam is being emitted.
Do not remove the cover of an unused card.
Connecting a LAN cable
Use the LAN cables listed in the following table to connect the LAN Card. Do
not use any other cable.
Table 4-1
specifications Maximum
Cable Length
Connector Type
Multi Mode Fibre
Core size: 50um
Cladding size:125um
Wave length:850nm
Bandwidth:2000MHz
300m LC
Do not connect LAN cable directly with this card. It is not likely to be
able to communicate. Please connect this card with the SWHUB.
