7
rear sock
et and scart details
Use this socket to
connect ordinary VHS,
S-VHS or Hi8
equipment to your TV.
(Connect VCR to AV1
for Viewlink).
Use this to connect
digital video
broadcasting
equipment and home
entertainment
systems to your TV.
This should be
permanently connected to
an RF source - i.e your
aerial antenna.
AV2 scart input
AV1 scart input
RF aerial socket
important note on installation
If you intend placing this TV into a cabinet or wall alcove, please ensure there is
at least a 100mm (10cm) gap to the sides, rear and top of the television. This is to
allow for adequate ventilation.
Do not allow soft furnishings, such as curtains to be draped over the TV whilst in
operation.
Never place the TV onto a carpet during normal operation - this could obstruct
ventilation slots on the base of the TV.
Always place the TV on a flat surface, or if supplied, the stand accessory.
Failure to observe the above guidelines could result in serious overheating of your TV, or
even, in extreme cases, fire.
Use this to connect
digital video
broadcasting equipment,
home entertainment
systems and DVD
players etc. to your TV.
AV4 scart input
This should be
connected to the Mains
Supply via the supplied
Mains Lead.
Mains Socket
This should be
connected to your
plasma screen via
the link lead.
Link Socket
Use this to connect to
your computer if
desired.
VGA input
These sockets can be used to connect to external equipment to
supply a picture only, (no menus or Text), e.g. to a video projector.
Output sockets (SVHS monitor out & video out)
AUDIO
VISUAL
CONTROL
(AVC) UNIT
PLASMA SCREEN
This should be
connected to the Mains
Supply via the supplied
Mains Lead.
Mains Socket
This should be
connected to your
AVC Unit via the link
lead.
Link Socket
These sockets can be
used to connect to
external amplifier or Hi-
Fi system.
audio output (RCA)
This socket can be
used to connect a
SubWoofer speaker.*
SubWoofer
Use this button if you wish to test the
functionality of the plasma screen without the
AVC unit being attached. Press and hold this
button for more than 5 seconds and a test
picture will be displayed on the screen.
test button
*If this product is used with an active SubWoofer, it is possible to change its frequency by
adjusting the LPF (Low Pass Filter) control on the Subwoofer speaker. This will enable you to
select the most suitable sound performance.
X832136-02-02.qxd 11/19/01 10:45 AM Page 7
