--- 15 ---
(10) Removal of the Carbon Brushes [29] from the Housing [25]
For removal of the Carbon Brushes [29], please refer to the Handling Instructions.
(11) Removal of Wiring Block (C) [28] (Fig. 12)
Remove the two D4 x 16 Tapping Screws [15]. Wiring Block (C) [28] can then be removed by pulling it
toward the rear while holding the Housing [25].
10-2. Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to the following points:
(1) Installation of the Carbon Brushes [29]
For installation of the Carbon Brushes [29], please refer to the Instruction Manual.
Fig. 12
(2) Assemble Spring (C) [73] and the D3.97 Steel Ball
[74] in the Change Knob [72] as shown in
Fig. 13.
Fig. 13
Gear Cover [51]
D3.97 Steel Ball [74]
Spring (C) [73]
D5 Retaining
Ring [75]
Change Knob [72]