Hitachi CE50-10, Instruction Manual

Page: 36 / 194

3.3 Turning off the power to the CE50-10
Shut down the OS, and then turn off the power to the unit.
3.3.1 Stopping the unit
To stop the unit:
1. Log in (or remotely log in) to the unit.
For the user name and password that are to be used for login, see 5.2 Logging in to the unit after powering it on
for the first time.
2. Run the following command to shut down the OS.
Before shutting down the unit, confirm that no other users are logged in.
$ shutdown -h 0
3. When the unit stops, the STATUS lamp is extinguished.
Note
To restart the unit after it is stopped, perform the steps in 3.3.2 Turning off the power to the CE50-10, and then
perform the steps in 3.2 Turning on the power to the CE50-10. At this time, after turning off the power to the unit,
wait at least 1 minute ( 3.3.2 Turning off the power to the CE50-10 ) before turning the power on again ( 3.2
Turning on the power to the CE50-10 ). If the interval is less than 1 minute, the unit might not start normally.
3.3.2 Turning off the power to the CE50-10
To turn off power to the CE50-10:
1. Make sure that the unit has stopped (for details, see 3.3.1 Stopping the unit).
2. Turn off the MAIN POWER switch (MAIN POWER).
3. When the power is turned off, the POWER lamp (POWER) is extinguished.
4. Remove the power cable from the outlet.
Note
After turning off the power, wait at least 1 minute before turning on the power again. If the interval is less than 1
minute, the unit might not start normally.
3. Operating the Power Supply of the CE50-10
20