Hitachi C11XM25, Service Manual

Page: 3 / 72

3
CP-X444(C11XMB)/CP-X440(C11XM25)
3. Names of each part
Part names
●
Y
VIDEO
RGB IN1 RGB IN2
RGB OUT CONTROL
AUDIO 1-IN
S-VIDEO
COMPONENT VIDEO
C
B
/P
B
C
R
/P
R
R-AUDIO 2-L
AUDIO-OUT
Lens
Filter cover
(Air fi lter and intake vent
are inside.)
Elevator button
Elevator foot
Remote sensor
Zoom knob
Focus ring
Vent
AC inlet
Power switch
Elevator button
COMPONENT
VIDEO ports
Y
C
B
/P
B
C
R
/P
R
S-VIDEO port
VIDEO port
CONTROL port
Lamp cover
(Lamp unit is inside.)
Elevator foot
B
Front-Right side
Rear-Left side
Control buttons
(See the following page.)
Ports (See below.)
Vent
AUDIO-OUT port
Ports
AUDIO 1-IN port
AUDIO 2 L/R port
RGB IN1 port
RGB IN2 port
NOTE (*) About Restart switch:
This projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar, and before
turning on again, make the projector cool down at least 10 minutes without
operating. Only push the Restart switch in these exceptional instances.
Speaker
Restart switch (*)
RGB OUT port