3
STANDARD ACCESSORIES
(1) Box wrench ............................................................... 1
(2) Guide .......................................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
(1) Diamond wheel (Dia. 106 mm) for the fiber cement
boards.
(2) Carbide Tipped Saw Blade (Dia. 125 mm) for the
gypsum board.
(3) Rubber Adapter (Fig. 15)
Optional accessories are subject to change without
notice.
APPLICATION
(1) Cutting the hard boards types T9 and T7.
(ex. harditex, hardiflex, etc.)
(2) Cutting the gypsum board.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. Prepare a wooden workbench (Fig. 1)
Since the saw blade will extend beyond the lower
surface of the lumber, place the lumber on the
workbench prior to cutting. If a square block is
utilized as the workbench, adjust leveling to ensure
that it is properly stabilized. An unstable workbench
will result in hazardous operation.
CAUTION:
●
To avoid possible accident, remains always ensure
that the portion of workpiece after cutting is securely
anchored or held in position.
Fig. 1
ADJUSTING THE SAW PRIOR TO USE
1. Adjusting the cutting depth
As shown in Fig. 2, hold the handle with one hand
while loosening the lever with the another hand.
The cutting depth can be adjusted by swiveling the
base to the dasired position. In such manner adjust
the cutting depth and then securely tighten the
lever.
Fig. 2
SPECIFICATIONS
Model
C5YA
Voltage
230 V
Cutting Depth
37 mm Max.
Power Input
1000 W
Capacity
125 mm Max.
Full Load Amp.
4.6 A
Dimensions (Length
×
Heigth
×
Width)
284 mm
×
208 mm
×
320 mm
No Load Speed
5000/min
Weight (without cord)
3.1 Kg
Workpiece
Base
Workbench
Saw Blade
Lever
Handle
Base
