35
English
WARNING:
Always
fi
rmly clamp or vise to secure the crown molding to the
fence; otherwise the crown molding might be thrust from the
table and cause bodily harm.
Do not bevel cutting. The main body or saw blade may contact the
sub fence, resulting in an injury.
CAUTION:
Always con
fi
rm that the motor head (see Fig. 1) does not contact
the crown molding vise ass’y when it is lowered for cutting. If there
is any danger that it may do so, loosen the hex. socket set screw
and move the crown molding vise ass’y to a position where it will
not contact the saw blade.
Position crown molding with its WALL CONTACT EDGE against the guide fence and its
CEILING CONTACT EDGE against the crown molding Stoppers as shown in Fig. 45-b.
Adjust the crown molding Stoppers according to the size of the crown molding.
Tighten the 6mm wing bolt to secure the crown molding Stoppers.
Refer to the lower table for the miter angle.
Position in Fig. 36
Miter angle
Finished piece
For inside corner
1
Right 45°
Save the right side of blade
2
Left 45°
Save the left side of blade
For outside corner
3
Save the right side of blade
4
Right 45°
Save the left side of blade
13. Groove cutting procedures
Fig. 46
ⓐ
ⓑ
ⓑ
Cut grooves with saw blade
Fig. 47
Stopper
holder
Bottom line of
the groove
Turntable
Hinge
Turn
6 mm depth
adjusatment bolt
Grooves in the workpiece can be cut as indicated in Fig. 46 by adjusting the 6 mm depth
adjustment bolt.
Cutting depth adjustment procedure:
(1) Turn the stopper holder on the direction shown in Fig. 47.
Lower the motor head, and turn the 6 mm depth adjustment bolt by hand. (Where the
head of the 6 mm depth adjustment bolt contacts the hinge.)
0000Book̲C12RSH2.indb 35
0000Book̲C12RSH2.indb 35
2016/03/01 18:07:38
2016/03/01 18:07:38
