— 13 —
English
BLADE GUARD ASSEMBLY (Fig. K, L, M)
1.
Set the blade to maximum height and the tilt to zero
degrees on the bevel scale with the hand wheels. Lock
the blade lock knob.
2.
Place the external toothed lock washer (1), a steel flat
washer (2) and a spring washer (10) onto the long hex
head bolt (3). Insert the bolt into the splitter bracket (4)
as shown. (Fig. K)
Fig. K
4
11
3
2
1
10
3.
Place the oval washer (5) on the pivot rod (6). (Fig. L)
4.
Install the bracket assembly (4) at the rear of the saw
table and snugly – do not tighten. Thread the bolt (3)
into the internally threaded pivot rod.
NOTE:
The splitter is removed from the illustration for
clarity.
Fig. L
6
5
5.
Position the blade guard arm (7) to the rear of the
table.
6.
Using a straight edge, check to see if the blade guard
splitter (8) is aligned with the saw blade (9).
7.
If straightening adjustment is necessary, loosen the
bolt (3) and shift the splitter assembly to right or left,
or rotate.
8.
When the splitter is properly aligned with the saw
blade, tighten the bolt tightly.
9.
If height adjustment is necessary, loosen the bolts (11)
and raise the splitter assembly to the desired height
and tighten the bolts. (Fig. K)
10.
NOTE:
The splitter must always be correctly aligned
so that the cut workpiece will pass on either side
without binding or twisting to the side.
WARNING
Improper splitter alignment can cause “kickback” and
serious injury.
Kickback pawl
7
9
3
8
Fig. M
INSTALLING TABLE SIDE EXTENSIONS (Fig. N)
1.
Identify the right hand table extension.
NOTES:
For illustration purposes the view in Fig. N looks
“through” the saw table to the under side of the table.
The right hand table extension is the one with the
measuring scale (1) visible from the front of the saw
when it is installed to the right hand side of the saw
table (Fig. N).
2.
Open both front and rear cam locking levers (2) on the
right hand side of the saw base by pulling them out
from the cam locking assemblies (4).
3.
Insert the table extension mounting tubes (3) into the
two matching holes in the cam lever assemblies.
NOTE:
Make sure the front mounting tube has the
measuring scale visible from the front of the saw.
4.
Slide the table extension toward the table until it rests
against the saw table.
5.
Lock both cam locking levers by pushing them in
toward the cam locking lever assemblies.
4
2
3
Fig. N
