24
3WPL079591-2
How to Install the Washing Machine
●
Water supply hose
■
Optimum water pressure is 0.03-0.8MPa.
■
Do not connect to the mixer tap of an unpressurised hot-water
apparatus.
■
Use a horizontal tap.
Horizontal tap
Extension tap
Square tap
Connect the water supply hose to the rear panel of
the washing machine.
Make sure that the rubber seal is inside the hose
connector.
Rubber seal
Hose connector
* Model with SCREW TYPE water supply hose.
Firmly connect the water supply hose to the tap, and
check connection points for water-tightness.
* Model with ONE TOUCH JOINT water supply hose.
1.
Untighten the upper connector
screw.
Upper connector Rubber packing
Fixing screw
Middle
connector
●
In case the diameter of the tap
is large remove the guide plate.
Guide plate
Connector
2.
Push the upper connector up
till the rubber packing is in
tight contact with the tap. Then
tighten the 4 screws.
Rubber packing
Upper connector
Middle connector
●
Turn the middle connector so
that there is no water leak.
3.
Connect the water supply
hose to the middle connector,
pushing the plate down.
Middle connector
Water supply hose
●
To separate the water supply
hose from the middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.
Conecting the
water supply
24
3WPL079591-2
How to Install the Washing Machine
●
Water supply hose
■
Optimum water pressure is 0.03-0.8MPa.
■
Do not connect to the mixer tap of an unpressurised hot-water
apparatus.
■
Use a horizontal tap.
Horizontal tap
Extension tap
Square tap
Connect the water supply hose to the rear panel of
the washing machine.
Make sure that the rubber seal is inside the hose
connector.
Rubber seal
Hose connector
* Model with SCREW TYPE water supply hose.
Firmly connect the water supply hose to the tap, and
check connection points for water-tightness.
* Model with ONE TOUCH JOINT water supply hose.
1.
Untighten the upper connector
screw.
Upper connector Rubber packing
Fixing screw
Middle
connector
●
In case the diameter of the tap
is large remove the guide plate.
Guide plate
Connector
2.
Push the upper connector up
till the rubber packing is in
tight contact with the tap. Then
tighten the 4 screws.
Rubber packing
Upper connector
Middle connector
●
Turn the middle connector so
that there is no water leak.
3.
Connect the water supply
hose to the middle connector,
pushing the plate down.
Middle connector
Water supply hose
●
To separate the water supply
hose from the middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.
Conecting the
water supply