90
Symptom
Possible cause
Solution
Powe
r
The power does
not turn on.
Is the power plug connected to a power outlet?
Connect the power plug to a power outlet.
The operation
stops or the power
turns off while in
progress.
Did a power outage occur? Did a fuse blow or a
short circuit occur?
Press the <ON> button, and restart the operation.
Is there an appliance that emits noise, such as
a television or radio, near the machine?
z
If noise continuously enters the machine, the
power will turn off.
Disconnect the power plug and reconnect it,
and then press the <ON> button and restart the
operation. Do not place televisions and radios
near the machine.
z
If the temperature of the drum rotation
motor reaches a certain level, the power is
automatically turned off for safety.
This is not a malfunction.
Wait about 1 hour before restarting the operation.
The power turns
off while the
drying operation is
paused.
z
Did you leave the machine paused for more
than 15 minutes?
This is not a malfunction.
Restart the operation in 15 minutes.
<S
T
A
R
T
> b
u
tt
o
n
Operations do not
start even when
the <START>
button is pressed.
Is the <DELAY START> function set?
If you want to start the operation immediately,
cancel the delay.
(P. 62)
The water drains
when the <START>
button is pressed.
z
If the drum is full (about 30 L) when you start
an operation, it will be drained before the
operation starts.
This is not a malfunction.
Det
er
gent
ca
se
Water remains in
the detergent case.
z
As liquid detergent and softener are added by
injecting water and creating a siphon effect,
water may remain in the detergent case.
If this is a concern, empty the water or wipe it off,
or clean the detergent case.
(P. 80)
Is the cap attached?
Make sure the cap is attached securely.
Are the inlets and cap dirty, or is detergent or
softener caked on them?
Clean the detergent case.
(P. 80)
Is the machine installation level?
(Installation
Instructions)
z
If the machine is not level, the siphon effect will
not occur and the water in the detergent case
will not drain properly.
Make sure the air bubble in the spirit level is inside
the circle.
Dr
y
fi
lt
er
The dry filter is
wet.
Did you stop an operation while it was in
progress?
z
If you stop a drying operation before the laundry is
completely dry, the dry filter may be wet.
This is not a malfunction.
Is the dry filter clogged?
z
If so, the dry filter may get wet.
Clean the dry filter.
(P. 78, 79)
z
If you leave the dry filter in a wet state, mold
growth may occur.
Remove the dry filter, and allow it to dry naturally.
Dust does not
accumulate in the
dry filter.
Did you set the dehumidification mode during
drying operations to Water Cooling Mode?
z
When the Water Cooling Mode is used, dust
is discharged together with the water used
for cooling dehumidification and may not
accumulate in the dry filter significantly.
This is not a malfunction.
Troubleshooting
(continued)
