Installation area
WARNING
！
Unpacking the washing machine
WARNING
！
Remove transport bolts
WARNING
！
8
Installation
Stability is important to prevent the product from
●
wandering!
Make sure that the product should not stand on
the power cord.
●
w
w
W 20mm
>
Before installing the machine, the location characterized
follows shall be selected:
1. Rigid, dry, and level surface
2. Avoid direct sunlight
3. Sufficient ventilation
4. Room temperature is above 0°C
5. Keep far away from the heat resources such as coal or gas.
●
●
Packaging material (e.g. Films, Styrofoam) can be
dangerous for children.
There is a risk of suffocation ! Keep all packaging
well away from children.
1. Remove the cardboard box and styrofoam packing.
2. Lift the washing machine and remove the base packing.
foam is removed with the bottom one together. If not, lay the unit down with side
surface, then remove the small foam from the unit bottom manually.
Make sure the small triangle
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum.
●
●
You must remove the transport bolts from the backside before using the product.
You’ll need the transport bolts again if you move the product, so make sure keep
them in a safe place.
Please take the following steps to remove the bolts:
1. Loosen 4 bolts with spanner and then remove them.
2. Stop the holes with transport bolts.
3. Keep the transport bolts properly for future use.
