21
42PD9800TA (FW1)
Item
Power Unit Vs Adjustment
Preparation Procedure
(1) Turn on the set and perform
pre-heat run more than 1 min
on burn-in screen.
(1) Turn Vs ADJ to adjust Vs voltage
to be within ±0.1V of the value
specified in the label on the panel.
Adjust within ± 1V at Vs1
Adjust within ± 0.1V at Vs2
(2) (2)
Connect voltmeter leads to Vs
and GND test points of the power unit.
Label example
<LOT>N6
Vs= 80.0V Va=60.0V
Vw=140.0V Vx=60.0V
Reconfirm that Vs voltage remains within
±0.45V of the specified value.
Readjust if it’s outside of the margin.
Vs1:Vs coares
adjustment VR
Vs2:Vs
fi
ne
adjustment VR
1
2
3
CN99:Vs test point
(Va)
Vs
GND
Summary of Contents for 42PD9800TAFW1
