Installation
- 9 -
may reduce remote control transmitter range.
Adequate ventilation is essential to prevent internal component failure. Keep away from areas of
excessive heat or moisture. To insure optimum color purity do not position magnetic equipment
(motors, fans, other speakers, etc.) nearby.
Optional External Equipment Connections
The Audio/Video connections between components can be made with shielded video and audio
cables. For best performance, video cables should utilize 75 ohm coaxial shielded wire. Cables
are available from your dealer or electronic supply house.
Before you purchase any cables, be sure you know what type of output and input connectors your
various components required. Also determine the length of cable you'll need.
AC Power Supply Cord
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT OF THE AC OUTLET AND FULLY INSERT. DO NOT USE THIS (POLARIZED) PLUG
WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
Remote Control Battery Installation
Remote and Battery Compartment Illustration
Batteries: Use two "AA" batteries.
1. Remove the battery compartment cover on the back of the remote.
2. Install the batteries in the battery compartment.
(Polarity (+) or (-) must be correct.)
3. Reattach the battery cover.
NOTE:
For frequent Remote Control users, replace old batteries with Alkaline batteries for longer life.
Precaution on Battery Use
Incorrect installation can cause battery leakage and corrosion that will damage the Remote
Control.
Observe the Following Precautions:
1. Batteries must be replaced as a pair.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (Example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when Remote Control reacts sporadically or stops
operating the television.
Antenna/Cable Connections
Antenna Connection -
For proper reception of VHF/UHF channels, external antenna is required.
For best reception an outdoor antenna is recommanded.
Antenna Mode must be set to TV.
(Refer to the Antenna section located in the Set-Up Menu.)
