- 6 -
2. Lubrication
(1) Apply ATTOLUB MS No. 2 Grease (Code No. 309922) to the following parts:
•
Teeth of the Armature
[25] <25>
and the Gear
[13] <13>
(with a brush)
•
On the Spindle
[6] <6>
Ground portion for fitting the Ball Bearing 6002VVCMPS2L
[9] <9>
, splined portion and hole on the
rear side
•
Surface of Steel Ball D6.35
[14] <14>
•
Lip portion of the Dust Seal
[5] <5>
•
On the Ratchet
[17] <17>
Inside the Needle Bearing, teeth of ratchet
•
Inside the Gear Cover
[12] <12>
: 5 g
3. Tightening torque
(1) Tapping Screw D4 -------------------------------------------------1.5 to 2.5 N•m (13.3 to 22.1 in-lbs.)
(2) Drill Chuck-----------------------------------------------------------30 to 50 N•m (266 to 443 in-lbs.)
(3) Machine Screw M3 (Switch
[41] <40>
)-----------------------0.4 to 0.8 N•m (3.5 to 7.1 in-lbs.)
(4) Flat HD. Screw (A) (Left Hand) M6 X 25
[1] <1>
----------4.4 to 5.4 N•m (38.9 to 47.8 in-lbs.)
(5) Bolt M3
[19] <19>
-------------------------------------------------1.2 to 1.8 N•m (10.6 to 15.9 in-lbs.)
4. Change Plate
Place the Change Plate
[20] <20>
between the Ratchet
[17] <17>
and Bushing
[18] <18>
before
assembling in the Inner Cover
[21] <21>
. (Fig. 10)
5. Change Lever
Push the Change Lever
[22] <22>
forward until the front end of the Change Plate
[20] <20>
protrudes
about 1.5 mm. (Fig. 11)
Fig. 10
Change Lever
[22] <22>
Fig. 11
1.5
Change Plate
[20] <20>
Bushing
[18] <18>
Ratchet
[17] <17>
Change Plate
[20] <20>
Place the Change Plate
[20] <20>
between the Ratchet
[17]
<17>
and Bushing
[18] <18>
before assembling.
