- 3 -
6. Removal of the drill chuck
[For DV 13SS, DV 16SS]
The Drill Chuck 13VLRC-D
[3]
is secured to the Spindle
[6]
with 1/2"-20 UNF (right hand) and Flat Hd.
Screw (A) (Left Hand) M6 x 25
[1]
. At first, open the chuck jaw as far as possible and loosen Flat Hd. Screw
(A) (Left Hand) M6 x 25
[1]
by turning it clockwise.
(a) Hold the drill so that only the Drill Chuck 13VLRC-D
[3]
rests firmly and squarely on the edge of a solid
bench. Insert the hex. bar wrench into the drill chuck. Turn the drill chuck until the wrench is at about a
30
°
angle to the bench top, and then sharply strike the wrench with a hammer so the drill chuck turns in
the counterclockwise direction. (Fig. 4)
[For DV 13VSS, DV 16VSS]
The Drill Chuck 13VLRC-D (or The Drill Chuck 13VLRJ-N (W/O Chuck Wrench))
<3>
is secured to the
Spindle
<6>
with 1/2"-20 UNF (right hand) and Flat Hd. Screw (A) (Left Hand) M6 x 25
<1>
. First, open the
chuck jaw as far as possible and loosen Flat Hd. Screw (A) (Left Hand) M6 x 25
<1>
by turning it clockwise.
(a) Hold the drill so that only the Drill Chuck 13VLRC-D (or The Drill Chuck 13VLRJ-N (W/O Chuck
Wrench))
<3>
rests firmly and squarely on the edge of a solid bench. Insert the hex. bar wrench into the
drill chuck. Turn the drill chuck until the wrench is at about a 30
°
angle to the bench top, and then
sharply strike the wrench with a hammer so the drill chuck turns in the counterclockwise direction. (Fig.
4)
If the drill chuck cannot be removed by striking the wrench, do not forcibly strike the wrench forcibly and
try another way as follows.
(b) Hold the Spindle
[6] <6>
with an open end wrench secured to the vise as shown in Fig. 5.
Mount the pipe onto the hex. bar wrench. Turn the hex. bar wrench counterclockwise to loosen the drill
chuck. (Fig. 5)
Fig. 5
Open end wrench
Vise
Turn it counterclockwise.
Pipe
Hex. bar
wrench
Fig. 4
Hex. bar
wrench
Flat Hd. Screw (A)
(Left Hand) M6 x 25
[1] <1>
Loosen
