Hisun Motors HS5D-EV, Manual, Page: 35 / 76

35
1)
0x4886 Inch Fault
Inch switch active along with
any drive switch active
(excluding inch switches), seat
switch indicating operator
present or handbrake switch
active.
4887 Overload Fault Vehicle overloaded
4888 Raised and Tilted Fault
Scissor lift platform raised and
tilted
4889 Pothole Fault
Scissor lift pothole protection
active
488A Traction Inhibit Fault
Traction function inhibited using
traction inhibit switch (0x2137)
488B Illegal Mode Change Fault
Vehicle changed from traction
mode to pump mode (or vice
versa) when direction selected
488C Tilt Sensor Fault
Aichi error code (0x3802,0) set
to 0x02
488D Belly fault Belly function has activated.
488E Mom dir fault
Fault with momentary direction
selection switch
4941 Motor Overspeed
4942 PST Fault
An issue has occurred with the
PST unit
4981 Throttle Fault
Throttle value (0x2620,0) is
greater than 20% at power up.
4982 E-Brake Wire off
Wire-off detected in
electrobrake circuit
4983 Direction Change
Direction is changed and
vehicle speed is greated than
allowed in 0x2929,2
49C2 Entering Cutback
Controller has entered thermal
or voltage cutback region
4A01 Cutback
Thermal or voltage cutback
factors have reduced belowed
user defined levels.
4A81 RPDO Timeout (drive inhibit)
One or more configured RPDOs
not received with 3s at start up
or 500ms during normal
operation.
4B01 CAN off bus (drive inhibit)
CANbus off fault condition
detected on multinode system.
NOTE: This fault was added for
Aichi, to replace Very Severe
CAN off fault
4B02 Ren Data
Data missing from CAN
(Renault only)
4B03 IO Data Error
Vehicle application subsystem
is not receiving control or status
information.
4B81 CANopen anon EMCY level 2
EMCY message received from
non-Sevcon node and
anonymous EMCY level
(0x2830,0) is set to 2.
4C41 Too many slaves
Number of slaves (0x2810,0)
set higher than maximum