Control panel
ventilation, follow the instructions relevant
to installation.
Wherever possible the back of the product
should be against a wall to avoid touching
or catching warm parts (compressor,
condenser) to prevent the risk of a fire,
follow the instructions relevant to
installation.
The appliance must not be locate close to
radiators or cookers.
Make sure that the mains plug is
accessible after the installation of the
appliance.
Any electrical work required to do the
servicing of the appliance should be
carried out by qualified electrician or
competent person.
This product must be serviced by an
authorized Service Center, and only
genuine spare parts must be used.
1)If the appliance is Frost Free.
2)If the appliance contains freezer compartment.
Service
Starting up and temperature regulation
The temperature selector knob is located
on the RH side of the refrigerator
compartment.
Important!
Normally we advise you select
setting of 2 or 3 or 4, if you want the
temperature warmer or colder please turn
the knob to lower or higher setting
accordingly. When you turn the knob to
lower which can lead to the more energy
efficiency. Otherwise, it would result the
energy-consuming.
Important!
High ambient temperatures (e.g.
on hot summer days) and a cold setting
(position 6 to 7) may cause the compressor
to run continuously or even non-stop!
Reason:
when the ambient temperature is
high, the compressor must run continuously
to maintain the low temperature in the
appliance
First use and Installation
Cleaning before use
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
some neutral soap so as to remove the
typical smell of a brand new product, then
dry thoroughly.
Important!
Do not use detergents or
abrasive powders, as these will damage the
finish.
Installation Positioning
Warning!
Before installing, read the
instruction carefully for your safety
and correct operation of the appliance.
Position the appliance away from sources
of heat such as stoves, radiators, direct
sunlight etc.
Maximum performance and safety are
guaranteed by maintaining the correct
indoor temperature for the class of unit
concerned, as specified on the rating
plate.
Insert the plug of the connection lead into
the plug socket with protective earth
c o n t a c t . W h e n t h e r e f r i g e r a t o r
compartment door is opened, the internal
lighting is swiched on.
1
4
Setting “0” means:Off
T u r n i n g c l o c k w i s e i n d i r e c t i o n
Refrigerating unit on, the latter then
operating automatically.
Setting “1” means:
Highest temperature,
warmestsetting.Setting “7” (end-stop)
means:Lowest temperature,coldest
setting.
At a low ambient temperature of around
16 °C,setting 1 should be selected. At
ambient temperatures of around 25
°C,select setting 2. If you require a lower
temperature, select setting 3 or 4.
