Warning!
Before installing, read the
instruction carefully for your safety
and correct operation of the appliance.
5
Stand your appliance in a dry place to
avoid high mosture.
Appliances must not be exposed to rain.
Sufficient air must be allowed to circulate in
the low rear section of the appliance, as
poor air circulation can affect performance.
should be positioned away from
heat sources such as heaters and direct
5
Important!
For this reason,
space should be
available around the
. It is
advisable for there to be
separating the back of the
to
the wall at least
of space
on its two
of over
from its top and a clear space
in front to allow the doors to open 180°.
It is necessary to have good
ventilation around the refrigerator to allow for
the dissipation of heat, high efficiency, and
low power consumption.
sufficiently cleared
refrigerator
refrigerator
sides, a height
First use and Installation
Cleaning before use
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
some neutral soap so as to remove the
typical smell of a brand new product, then
dry thoroughly.
Important!
Do not use detergents or
abrasive powders, as these will damage the
finish.
Installation Positioning
This appliance performs well within the
Ambient temperature from 55 deg F /
12.8
℃
to 110 deg F / 43.3
It
may
not
work
properly if being left at a
temperature above or below the indicated
range for a long period.
℃.
State of California Proposition 65 Warnings:
WARNING:
This product contains one or more chernicals known to the State of California to
cause cancer.
WARNING:
This product contains one or more chernicals known to the State of California to
cause birth defects or other reproductive harm.
Keep the appliance out of direct sunlight
rain or frost. Stand the appliance away
from heat sources such as stoves, fires or
heaters.
Installing
the
rubber
anti-tip pad
If
there is a rubber anti-tip pad and
a screw provided in a plastic bag with
your appliance ,you must install these
accessories according to the following
procedure.
lo wer base cover
1.Tilt appliance to find screw hole on the
left of lower base cover.
75 mm / 3 inches
100 mm / 4 inches
100 mm /
4 inches
Appliances
sunlight.
75 mm / 3 inches
100 mm / 4 inches
100 mm / 4 inches
Note:
There is no need to install these accessories under
normal usage, Only under the extreme circumstance,
cabinet empy while load on door with local mass of
10 kg / 22 pounds and opening the door about 90
degree, this refrigerator may take risk of tipping, Then
anti-tip should be fastened to the lower base cover to
steady this appliance.
