11
Cleaning and care
For hygienic reasons the appliance
(including
exterior
and interior
accessories)
should
be cleaned
regularly at least every two months.
Caution!
The appliance must not be
connected to the mains during cleaning
to avoid potential electrical shock. Before
cleaning, please
the appliance
switch off
off and remove the plug from the mains
Exterior cleaning
To maintain good appearance of your
appliance,you should clean it regularly.
-Wipe the digital panel and display
panel with a clean, soft cloth.
-Spray water onto the cleaning cloth
instead of spraying directly on the
surface of the appliance. This helps
ensure an even distribution of moisture
to the surface.
-Clean the doors, handles and cabinet
surfaces with a mild detergent and
then wipe dry with a soft cloth.
Caution!
-Don't use sharp objects as they are
likely to scratch the surface.
-Don't use Thinner, Car detergent,
Clorox, ethereal oil, abrasive cleansers
or organic solvent such as Benzene for
cleaning. They may damage the
surface of the appliance and may
cause fire.
Interior cleaning
You should clean the appliance interior
regularly. It will be easier to clean
when food stocks are low. Wipe the
inside of the fridge freezer with a weak
solution of bicarbonate of soda, and
then rinse with warm water using a
wrung-out sponge or cloth. Wipe
completely dry before putting the
shelves and baskets back.
Thoroughly
dry all surfaces and
removable parts.
Although this appliance automatically
defrosts, a layer of frost may occur on
the freezer compartment's interior walls
if the freezer door is opened frequently
or kept open too long. If the frost is too
thick, choose a time when the supply of
food stocks are low and proceed as
follows:
1.Remove existing food and
accessories baskets, unplug the
appliance from the mains power and
leave the doors open. Ventilate the
room thoroughly to accelerate the
thawing process.
2. When defrosting is completed, clean
your freezer as described above.
Caution!
Don't use sharp objects to
remove
frost
from
the freezer
compartment. Only after the interior is
completely dry should the appliance be
switched back on and plugged back
into the mains socket.
Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash seal with a
mild detergent and warm water. Rinse
and dry it thoroughly after cleaning.
Caution!
Only after the door seals are
completely dry should the appliance be
powered on.
Replacing the LED light:
Warning!
The LED light must not be
replaced by the user! If the LED light is
damaged,
contact
the customer
helpline for assistance. To replace the
LED light, the below steps can be
followed:
1. Unplug your appliance.
2. Remove light cover by pushing up
and out.
3. Hold the LED cover with one hand
and pull it with the other hand while
pressing the connector latch.
4. Replace LED light and snap it
correctly in place.
Hisense Refrigerator
socket.
Summary of Contents for Refrigerator
Page 1: ......
