- 10 -
Installation
The appliance must be installed only by a qualified person
in compliance with instructions provided
. The
manufacturer declines all responsibility for improper
installation which may harm persons and animals and
damage property.
Important
: The power supply to the appliance must
be cut off before any adjustments or maintenance
work is done on it.
Positioning:
Important:
this appliance may be installed and used
only in permanently ventilated rooms in compliance
with current National Norms. The following
requirements must be observed.
a)
The room must be equipped with an exhaust
system that vents the combustion fumes to the
outside. It may consist of a hood or and electric
fan that automatically starts each time the
appliance is turned on.
A flue or branceed flue system Directly
(only for cooking appliances) to the Outside
b)
The room must also have a system that allows
for normally. The flow of air needed for
combustion must not be less than 2 m3/h per KW
of installed power. The air circulation system may
take air directly form the outside by means of a
pipe with an inner cross section of at least 100
cm2; the opening cannot under any
circumstances be blocked accidentally(Fig A), The
system can also provide the air needed for
combustion by indirect means. i.e. form adjacent
rooms fitted with air circulation tubes as
described above. However, these rooms must be
common rooms, bedrooms or rooms with a fire
hazard( Fig. B)
Details A
Adjacent Room
Room to be ventilated
Fig A Fig B
Examples of Ventilation Opening Increasing opening
For comburent Air between door and floor
c)
Liquefied petroleum gas is heavier than air and,
therefore, settles downwards. Thus, rooms
containing LPG cylinders must also be equipped
with apertures to the outside for ventilation of
gas in the event of leaks. LPG cylinders must not,
therefore, be installed or stored in rooms or
storage areas that are below ground level(cellars,
etc.) whether they are partially or completely full.
It is a good idea to keep only the cylinder being
used in the room, positioned so that it is not
subject to heat produced by external sources
(ovens, fireplaces, stoves, etc.) which could raise
the temperature of the cylinder to the above 50.
Prior to installation, ensure that the local distribution
conditions (nature of the gas and gas pressure), and
the adjustment of the appliance are compatible.
The adjustment conditions for this appliances are
stated on the label(or data plate)
This appliance is not connected to a combustion
products evacuation device. It shall be installed and
connected in accordance with current installation
regulations. Particular attention shall be given to the
relevant requirement regarding ventilation.
Installation of Build-in Ovens
In order to ensure that build-in appliance functions
properly, the cabinet containing it must be
appropriate. The figure below gives the dimensions
of the cut-out for installation under the counter or in
a wall cabinet unit.
Summary of Contents for HGO601BS
Page 29: ......
