Hisense H6500TS, User'S Operation Manual

Page: 7 / 16

1. Remove the light cover .
2. Use the cross screw driver to take the
screw out .
3. Pull out the joint cable, and take down the
old LED light.
4. Replace with a new LED light that is
same to the origin, screw the screw in.
5. Replace
the light cover .
Unplug the mains plug.
Press the bulb in the center with finger.
Warning! If the LED light bulb is
damaged, DO NOT CHANG IT BY
THE USER!
Before changing the light bulb, switch off
the appliance and unplug it, or pull the
fuse or the circuit breaker.
To switch off the appliance.
Changing the light bulb carry out by
inexperienced persons may cause injury or
serious malfunctioning.it must be replaced
by a qualified persons in order to avoid a
hazard. Contact your local Service Force
Center for help.
Fast Freeze
If you need the temperature inside the
freezer to drop rapidly , press the FAST
FREEZE button, all the LED indicator are full
light, the freezer compartment will operate in
FAST FREEZE mode for 24 hours, and the
setting temperature is
-23 C . If you change
the temperature setting, the fridge will exit
FAST FREEZE mode.
ATTENTION: Normally we advise you
setting the temperature on “Mid”position.A
colder setting on the temperature regulator
means
more energy will be consumed. In
FAST FREEZE mode the compressor will
run continuously or even non-stop!
FRIDGE TEMPERATURE
When the machine is not in the
temperature setting mode, If you want to
set the temperature inside the fridge , you
can follow the two steps below:
1. Press “select
” button, until the fridge light
is on, and the LED indicator will indicate the
current temperature
setting in fridge.
2. Then you can set the temperature from
1 C to 9 C by pressing and , press the
button once, the temperature will increase or
decrease 1 C
, and the LED indicator will
turn down or turn up between “cold”and
“colder”
, until the required temperature is
displayed. There is a corresponding
relationship between temperature setting
and indicator lights, you can find it out in the
same table upper.
Changing the light bulb
Before changing the light bulb, either the
refrigerator or disconnect the electricity
leading into the refrigerator at the main
power supply. Failure to do so could result in
electrical shock or personal injury.
Fixing the handle
Before you use the product, please check
the handle
. If the handle
is loose, you should fix it with the hexangular
screwdriver in the clockwise direction, then it
can be used normally.
of the refrigerator
The freezer compartment consist of 2
sections. One is the 4-star section and the
other one is the 2-star section.
The temperature for 2-star section is
always below -12 , where the
temperature for 4-star section is
always below -18 .
C
C
Hisense Refrigerator