Hisense DH3020K1W, Use & Care Manual

Page: 8 / 24

1. Single Fan speed .
Press POWER to turn on or turn off the dehumidifier.
1. Humidity can be adjusted manually .
The display shows relative humidity.
1. When the dehumidifier is running, the display
shows the relative humidity of the room.
2. “CO” will be displayed when the dehumidifier
is operating in continuous mode.
3. In continuous mode, room humidity will
be displayed.
NOT
NOTE:
The humidity displayed is only for reference.
For accurate humidity, please check a hygrometer.
NOTE:
The de-icing function will turn off the compressor
if a low temperature condition occurs. When the
de-icer senses the correct operating temperature,
the compressor will cycle back on. Some freezing
is normal when dehumidifiers are used at low
temperatures.
If this light is on, the fan and the compressor will
stop running. This light indicates that you need to
check:
NOTE :
Once the relative humidity of the room hit the
desired setting, the compressor will stop and the
fan will be off periodically.
The fan may periodically turn on, to read the
humidity level, without the compressor running.
7
Empty Bucket Light
■ If the bucket is full, empty and re-install
bucket.
■ If the bucket is not in position, remove the
bucket and re-install it. Make sure the
bucket fits all the way into the dehumidifier
and the bucket light is off, or duhumidifier
will not run.
■ If the humidity level of the room is higher
than the desired humidity setting, the
compressor will turn on. If the humidity level
of the room is lower than the desired humidity
setting, the compressor will turn off, as well
as the fan.
1. Press the Plus or Minus button to set the
desired humidity level. Desired humidity in
the digital display will flash for 5 seconds
after operation.
3. To set the dehumidifier for continuous
operation, press the Minus button until “CO”
flash for 5 seconds and then display. In
continuous mode, room humidity will
be displayed .
NOT
NOTE:
If continuous mode is selected, the
dehumidifier will operate continuously at its
maximum dehumidification settings if
attached to a hose to drain or until the bucket
is full.
4. When the dehumidifier is operating in
continuous mode, press the Plus button and
then unit will stop the continuous running
and goes back to manual mode.
2. Actual room humidity will be displayed after
5 seconds of flashing the desired humidity.
Humidity Level
Fan Speed
Desired Humidity-Mode
Power
Digital Display
1. When the Clean Filter indicator light is on,
remove, clean and replace the air filter. See
“Cleaning the Air Filter”.
2. Press the POWER button for 5 seconds after
cleaning and replacing the air filter to reset
the filter monitor.
NOTE:
When the light is on, it will remain on for 180 hours
or until you press POWER button for 5 seconds.
Clean Filter