Installation Instructions
UM19.5A User Manual, 99159, March 2017
11
Step 3: Install the Monitor
Once you have completed the full bench-test configuration and confirmed that all components are
working properly, you are ready for final installation and mounting of the monitor.
WARNING!
Hope Industrial will not assume liability for damage to internal electronics due to
improper installation� Contact Hope Industrial if you need additional assistance�
!
Fully Assembled Workstations
If you purchased a fully assembled workstation, most of the assembly
has already been performed for you� For your reference, complete
installation instructions are shipped with the workstation should you need to
disassemble or reassemble it for any reason� They may also be found on
our website at the following address:
http://www�HopeIndustrial�com/Installations/99108�pdf
Install Cable Exit Cover Plate
Installation instructions vary slightly depending on the Cable Exit Cover Plate you ordered.
Complete installation instructions are shipped with each Cover Plate configuration and may also
be found on our website at the following addresses:
Conduit Cable Exit (CP-CON Series):
http://www�HopeIndustrial�com/Installations/99075�pdf
Pilot Hole Cover Plate (CP-BLNK Series):
http://www�HopeIndustrial�com/Installations/99077�pdf
Compression Gland (CP-GL Series):
http://www�HopeIndustrial�com/Installations/99033�pdf
Compression Gland (CP-RG Series):
CP-RG1:
http://www�HopeIndustrial�com/Installations/99071�pdf
CP-RG2:
http://www�HopeIndustrial�co�uk/Installations/99120�pdf
