MACH104
Release 09/09
21
The LED display elements should be clearly and easily visible.
Make sure that the TP cable is far enough away from power cables and
other sources of possible electrical interference.
Make sure that the device is connected to a separate power source with
a ground connection and a main voltage in line with the technical data,
and that the device is supplied with power via a separate isolator or power
switch. It is recommended to use overvoltage protection for all devices.
Note: The shielding ground of the connectable industrial twisted pair lines is
connected to the front panel as a conductor.
Mounting the MACH104 as a table unit
Install the device in line with the criteria listed in
„Installing the device
and grounding“
.
Mounting the MACH104 in a switch cabinet
The devices are designed to be mounted in a 19" rack.
Make sure there is sufficient ventilation. If necessary, provide a fan for
the 19" rack. This will prevent the basic devices from overheating.
Measure the depth of the 19" rack so as to allow the main cable, and
any power supply cables, to be fitted from the back, and the data ca-
bles to be fitted from the front.
If you are operating the device in a 19" switch cabinet, you must install
sliding/mounting rails (not included in the delivery) to hold the weight of
the device.
Warning
If the device is installed in a 19" switch cabinet without sliding/
mounting rails, increased vibration can cause damage to the de-
vice and/or its modules.
For more information on sliding/mounting rails and how to install them,
please contact your switch cabinet manufacturer.
Install the sliding/mounting rails in the 19" switch cabinet as instructed
by the manufacturer, and make sure the device is resting on both rails.
Summary of Contents for MACH104-20TX-F Series
Page 38: ......
