HIOTH
User Manual
HIOTH TECHNOLOGY CO.,LTD.
NOTE:
There are two powering modes for the sensor. By default it’s powered by a factory included bat-
tery. Alternatively it can work with a constant current, after connecting a 12/24 VDC power
source to +12/24 and GND terminal (Fig.1). Powering mode configuration is carried out automat-
ically, while sensor is being included into the Z-Wave network. When battery powered, a Smoke
Sensor communicates with the Z-Wave network main controller periodically. Smoke detection is
sent immediately. Configuration parameters and association settings are sent periodically at speci-
fied wake up intervals, or at a manual wake up (triple click B-button). In DC powering mode, con-
figuration and association parameters are sent when necessary, and additionally the smoke sensor
serves as a Z-Wave signal repeater.
Switching to a constant current powering mode:
1)
Exclude a sensor from the Z-Wave network.
2)
Disconnect the battery
3)
Install the constant power connecting terminal, observing the Fig.1
4)
Connect the constant current power to the terminal (12/24VDC) to +12 and GND terminals
(Fig.1)
5)
Include Smoke Sensor into the Z-Wave network.
Operation
Z-WAVE NETWORK INCLUSION
Smoke Sensor may be included into Z-Wave network via the B-button.
1)
Connect the power supply, and make sure that device in a state of "No node ID".
2)
Choose "Z-Wave" to enter the Network Inclusion mode on the APP, then click "
".