10
Attaching the driver bit
Always move the driver normal/
reverse selector switch to the “OFF”
position, or remove the drive power
plug from the power outlet so that it
is not powered when attaching or
removing driver bits.
Please take note that if the push-
start driver is powered, even the
slightest push can cause the driver
to rotate and cause unexpected
injuries.
•
To attach the driver bit,
push the joint shaft
collar down towards the
driver body and insert
the driver bit. Check that
the driver bit is firmly
locked after it has been
attached.
•
The VZ-1812 series and
VZ-3007 series has a
chuck to suit both the
HIOS shank H5 (Ø5) and the 5 mm wide hexagonal
bit (5HEX). Take note of the following precautions
when using the hexagonal bit.
•
Always use our standard HIOS shank type bits H4
(Ø4) and H5 (Ø5).
■
Types of driver bits that can be used with the
VZ-1812 series and VZ-3007 series
Caution
60mm
H5 (Ø5)
HIOS Driver Bit H5 (Ø5)
16mm
5mm wide
5mm wide Hexagonal W Bit
(Caution)
When using the HIOS
driver bit Ø5 or 5 mm
wide Hexagonal W
Bit, check that the
Phillips adjustment
screw within the
driver body has not
been tightened.
*If the Phillips adjustment
screw has been tightened
the driver bit may drop out.
Joint shaft collar
