- 12 -
Problem
Cause
Remedy
6-4
The screws on the rail do not feed
smoothly.
- The clearance between the holding plate
(screw guide 1) and screw heads is
insufficient.
- Dirt, oil, or grease is attached to the rail.
- The rail fails to vibrate due to a screw or
foreign object trapped in the opening.
- Shift the holding plate (screw guide 1) upward.
Use the Quicher in a tilted position.
Adjust the timer setting control.
- Clean the rail and rail guide.
- Remove the trapped screw or foreign object and
then clean the rail and rail guide.
6-5
Oddly oriented screws occasionally
travel through the passage window.
A screw shank easily gets caught in the
passage window.
- The passage plate is improperly adjusted.
- The employed passage plate does not match
the applied screw.
- The forward-descending tit of the machine is
above the permissible.
- Readjust the passage plate.
-Use the passage plate that matches the applied
screw.
- Adjust the tilting angle, make sure it is within the
permissible limit.
6-6
Screws are not transported to the re-
moval section.
Screws are stopped in the middle of the rail
section.
- Screws are not smoothly delivered from the
rail to the front stopper.
- Readjust the holding plate (screw guide 1).
- Readjust the passage plate.
6-7
The bit doesn’t match the Pillips head.
- The rail assembly is improperly adjusted.
- The bit guide is improperly adjusted.
- Readjust position between the rail and bit guide.
