Hioki MR8740-50, Instruction Manual

Page: 104 / 238

98
Trigger Setting Procedure
5.1 Trigger Setting Procedure
• The instrument is triggered based on trigger logical-conditions (logical AND or OR operation)
among trigger sources except for the forcible trigger. (p. 105)
• When triggered, the instrument outputs the TRIG OUT signal from the external control terminal.
(p. 213)
Configure the trigger function setting
Enables the trigger function. (p. 99)
Configuring the trigger timing setting
Specify the start timing of recordings
controlled by triggers.
(p. 100)
Configuring the pre-trigger settings
Specify a recording length that precedes
the start trigger point.
(p. 102)
Setting trigger logical-conditions (AND or
OR operation) among trigger sources
Setting trigger logical-conditions (AND or
OR operation) among the analog, logic,
external, and interval triggers to trigger the
instrument.
(p. 105)
Configuring the trigger type settings
Set trigger conditions for each trigger.
• Analog trigger (p. 106)
• Logic trigger (p. 114)
• Interval trigger (p. 116)
• External trigger (p. 118)
• Forcible trigger (p. 118)
Choosing a measurement mode
Choose whether the instrument repeatedly
waits for a trigger after a measurement has
been stopped.
(p. 6)
Starting a measurement
Click the start icon to start a measurement. (The key
green LED lights up.)
When a trigger condition is satisfied, the instrument
starts to acquire data.
To stop the measurement, click the stop icon.
Click the icon once: Stops the measurement once the
instrument has acquired the recording-length data.
Click the icon twice: Immediately stops the recording.