18
1.4 Names and Functions of Parts
Keys
Description
1
• Turns the power on and off.
• Holding down
while turning on the power initializes the saved measurement
data and the saved settings (returning them to their factory defaults).
See
For details on the factory defaults: 4.2 (P. 60)
• Holding down the
while powering up allows you to set the Auto
power off, audible key feedback, unit indication, slow function, and
MEM.MODE key enable/disable.
See
4.3 (P. 61)
2
Switches magnetic field measurement function/modes as show below:
Magnetic flux density (10 Hz to 400 kHz)
o
magnetic flux density (10 Hz to 2 kHz)
o
magnetic flux density (2 kHz to 400 kHz)
o
exposure level (General Public)
o
expo-
sure level (Occup.)
o
magnetic field density (10 Hz to 400 kHz)
o
...
See
3.3 (P. 40)
3
• Switches between Auto and Manual ranges.
Manual range:
(magnetic flux density mode) AUTO
o
r0
(2
P
T)
o
r1
(20
P
T)
o
r2
(200
P
T)
o
r3
(2 mT)
o
AUTO...
(exposure level mode) AUTO
o
r0
(20%)
o
r1
(200%)
o
AUTO...
Auto range:
automatically selects appropriate range during measurements.
• Switches measurement ranges during manual range.
See
3.3 (P. 40)
• Magnetic flux density switching is performed by converting from T (Tesla).
For this reason, for example, 1.592 A/m is the maximum indicated value in
the 1.6 A/m range.
4
• Use to output function.
• Switches between the following output functions.
OFF
o
Waveform output
o
resultant RMS value output
o
OFF...
• This mode disables the auto power off mode.
• The waveform output cannot be configured in exposure level function.
See
6.1 (P. 95)
5
• Holds the maximum value. (Each new maximum value updates the indicated
value.)
• Press this key again to unhold.
See
3.6 (P. 53)
6
Shows saved measurement data.
See
3.7 (P. 54)
1
8
7
6
5
4
3
2
keys
www.
.com
1.800.561.8187
