Hinowa HS701, User Manual - Machine Safety And Maintenance

Page: 81 / 108

79
C
OMPACT DUMPER
HS701 ‐ H
INOWA
MUHS70120615
‐ Measure the distance between the pins on 45 links in the chain.
The total measurement must not exceed 867 mm.
‐ If the measured distance exceeds this value, immediately replace the chain.
This check must be performed every month.
Every day check that the body sliding guide is clean.
6.7 ELECTRIC SYSTEM
6.7.1 B
ATTERY REPLACEMENT
Don’t touch with the key or other material both the poles of the battery becouse it’s
possible to damage the battery, the elettrical system or get an elettric shock.
6.7.1.1
STANDARD SKIP AND HI
‐
TIP VERSION
In order to replace the battery open the skip of the dumper , block it using the
cylinder safety locker and turn off the engine.
Disconect the pipe on the cylinder for lift the support and than remove it (only for
hi‐tip version).
Disconnect the battery swich and then remove the cablage of the battery and the
battery lock.
Remove the battery rotating it and moving it out upper the pump.Install a new bat‐
tery, block it using the battery lock and then reconnect all the component.
6.7.1.2
SELFLOADING VERSION
In order to replace the battery open the skip of the dumper , block it using the
cylinder safety locker and turn off the engine.
remove the battery cover and disconnect the battery swich and then remove the
cablage of the battery and the battery lock.
Remove the battery and install a new battery, block it using the battery lock and
then reconnect all the component.
6.7.2 B
ATTERY
Checking electrolyte (for batteries requiring maintenance) and terminals.
ATTENZIONE
CAUTION