Hiniker 9850, Operator'S Manual

Page: 16 / 33

14 V-Plow Assembly
links to the outside of the two lugs on the lift
frame, then pin the lift cylinder between the
two lugs on the frame assembly with the hard-
ware provided.
DWG. NO. 6007
Rotate the stop plate assembled to the push
frame up to contact the spacer bushing on
the lift cylinder bolt. Gently push back on
the upper lift frame tube, then release to al-
low the weight of the frame to lock the stop
plate in place.
3. Remove two 5/8 inch x 8 inch hex bolts
from the front of the pushframe and save
the hardware for reinstallation. Remove
shipping straps from between the center
mast and lugs on the back of the moldboard
assembly. Discard the straps and save the
hardware for reinstallation.
DWG. NO. 6001A
Move the frame assembly to the back of the
moldboard assembly and align three sets of
holes at the front of the frame assembly with
holes through the moldboard center mast.
Place a flat washer onto the three hex bolts
before inserting them through the holes.
Secure the bolts with flat washers and lock
nuts.
Pin the parking stand to hold the square tubes
of the pushframe parallel to the ground.
DWG. NO. 6002
The bottom surface inside the two prong re-
ceiver channels should measure about 10
inches above the ground in the working po-
sition.
Find two sets of upper and lower angle
braces in the parts box. From the hardware
bag, remove six 5/8 inch x 1 1/4 inch hex
bolts and one 5/8 inch x 7 inch hex bolt.
Also remove four 5/8 inch flat washers and
seven 5/8 inch lock nuts.
DWG. NO. 5994
Refer to drawing 5994 and install the angle
brackets between the center mast and the
pushframe.