INSTALLATION AND OPERATING INSTRUCTIONS
72-0112 03-06-18
7013500 314 SKLT 69 A
Page 22
Recessed Mounting For the Premium Control
The recessed mounting box allows the control to mount with its surface almost even to the wall surface. Print this page to
“Actual” Size on Printer Options. (This will ensure the size of the opening is correct). Cut out the middle of this page on the
dotted lines. The hole will be the size of the mounting box. Insert the mounting box in the hole of this page to ensure it is the
correct size.
Trace the paper cut out on the wall. Cut a hole in the wall to match the inner dotted line for the mounting box. Run the control
cable out of the wall through the hole in the mounting box. Ensure the hole is just big enough to mount the box. Push the
mounting box into the hole and turn the mounting screws to pull the tab tight against the inside of the wall. Ensure the box is
level and the correct end is UP (there is an arrow on the wall side of the box pointing up).PLATED COVER RING
Connect the Premium cable end to the control cable then feed the cables and connector through the hole in the box and into the
wall. Test the Premium Control before mounting it into the wall! Once mounted, the Premium Control will be hard to remove!
When ready, remove the adhesive tape from the back of the control, carefully push the control into the box, and hold in place.
Press the trim ring on to the front of the box and control. Snap it in, place top and bottom and along both sides
.
Print Page as “Actual” Size
Cut on Dotted Line and remove this part of page
Trace This Inner Opening on the Wall
Solid Line represents the outline of the housing lip.
Print page to “Actual Size”;
do not select “Fit” to page
on printer Page Sizing.
Level Line
SECTION 16: INSTALLATION PREMIUM CONTROL
(1601-33 or 1601-33-1)
OPERATION