14
English
2190975
*2190975*
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery charge state LEDs blink, please refer to the information given in the Troubleshooting
section.
3.6
Indication of overloading and overheating
The power tool is equipped with an electronic system to protect against overloading and overheating. The
power tool switches itself off automatically in the event of overloading or overheating. After releasing the
control switch, the power tool may not restart immediately when the switch is pressed again (while the power
tool is cooling down).
4
Technical data
VC 5-A22
Rated voltage (DC)
21.6 V
Rated current input
16 A
Weight in accordance with EPTA-Procedure 01 (measured with B22⁄5.2)
5.2 kg
Ambient temperature
−17 ℃ … 60 ℃
Storage temperature
−20 ℃ … 70 ℃
4.1
Noise and vibration information, measured in accordance with EN 60335-2-69
VC 5-A22
Sound pressure level (L
pA
)
70.9 dB(A)
Sound power level (L
WA
)
85.2 dB(A)
Uncertainty
2.4 dB(A)
Vibration emission value (a
h
)
< 2.5 m/s²
Uncertainty (K)
Is taken into account in
the stated value
5
Operation
5.1
Preparations at the workplace
Observe the safety instructions and warnings in this documentation and on the product.
WARNING The appliance may be operated only by authorized, trained personnel.
5.1.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.1.2 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶
Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶
Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.1.3 Removing the battery
1. Press the release buttons on the battery.
Printed: 02.08.2019 | Doc-Nr: PUB / 5397550 / 000 / 03
